How To Repair Or Install Zip Line Brake
Zip lines used to be a rare entertainment ride found in amusement parks in the past. But today, they are found everywhere. Many people install zip lines in their backyards. If you have got a spacey backyard, you can easily go for installing your own zip line there.
When you install your own zip line, it is very important to check the zip line brake. Zipline brake plays a significant role in determining your safety while involving in zip line activities. Normally, you get zip line brake along with your zip line kit purchase. However, it would get loosened over time. You would then have to replace that with new ones.
The steps for installing or replacing your zipline brakes are discussed below. Make sure that you have the following things in order to replace or install a zipline brake.
- Zip ties
- Block of wood
- Large screwdriver
- Eye loop
- Power drill
- Small bar clamp
One you have the aforementioned supplies, you can get started with installing or replacing the zip line brake. Remember that it is very important to have the assistance of a helper. With the help of an expert, you can surely avoid unnecessary mistakes.
To begin with, prepare the block. You can do this by cutting a slit on the wood (if you are using wood as the poles). The slit should come at the center of the blocks. Fit in the knot now. Make sure that no gap is left between the blocks. Next, prepare the bolt. The wood blocks should be lined up now and drilled. The holes should fit the bolts.
Next, choose a point in your zip line cable where it is easy for you to work on and then place the knot in the knothole. Repeat this step for the cable as well. The top piece should be placed on the top while the clamp should be used to hold it up. This way, you can bolt it up easily and safely.
After you have installed or replaced the zip line brake, get it tested. You should bring in an expert to test zipline brake. Never allow your kids to use the zip line before it is properly tested.